Here are a couple pictures of the frame with the stringers attached. Other than a few small tweaks the frame is ready for skinning. I've got to make the combing and paddle as well.
Subscribe to:
Post Comments (Atom)
About the Retrieval
The kayak is 10'10" long, 23" at it's widest point and 8.5" from depth to shear. The weight is just shy of 26 pounds. The frame is mostly made of clear pine from Menards. The stringers, gunwales, and most of the deck beams are pine. The masik and the three curved deck beams are made of western red cedar from Home Depot. Ribs are 3/4" wide and 1/4" thick, ripped from a kiln dried red oak 2"x4", purchased at Menards. The combing for the cockpit is also made from kiln dried red oak. The skin is 8 oz ballistic nylon coated with a two part urethane giving it a flexible tough coating.
About Me
Around the Summer of 2001 I slipped into a kayak for the first time. It was a plastic recreational kayak that I paddled down the Middle Loup river in Nebraska. I had so much fun I decided to purchase one for myself. During my research I came across Skin on Frame construction (SOF). I was instantly hooked and knew I had to build one for myself. Six years later I finally got around to getting the job done.
Categories
- DeSoto (4)
- Materials (2)
- Middle Loup (7)
- Retrieval (34)
- Technique (1)
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share License 3.0.
No comments:
Post a Comment